Verifying The Operation Of The Lg Access Point - LG LW1100AP Series User Manual

2.3 Verifying the Operation of the LG Access Point

The AP runs a series of self-tests on power-up and reports status using its LEDs.
When power-up begins, the following occurs:
a. The firmware begins running diagnostics, initializes minimal hardware.
b. After the firmware completes its diagnostics and hardware initialization. The
diagnostics then checks the RF module to see whether it is properly runs in the AP.
And then, the firmware downloads RF module operating program.
. Upon successful completion of the diagnostics and program download, After Radio
c
Link LED turns on and then turns off for a few seconds all the LED display steady
bright.
The diagnostics take approximately 30 seconds to complete after power-up. Upon
successful completion of the diagnostics, the LED pattern shown in below figure is
displayed.
If the AP fails to display the proper LED pattern, verify that you have correctly installed
the AP. If the AP still fails to display the LED pattern, refer to troubleshooting section.
Page 28 of 50