Connect the Exchange Lines
3- SLNet Configuration
The SL2100 includes on-board DSP resources for connection to VoIP service providers. There are 8 x VoIP
resources on board the CPU. It is possible to increase this to a maximum of 128 by adding the VOIPDB
hardware and licenses.
This table shows the quantity of resources required for common call scenarios.
SIP Trunk
Digital/Analog/Hybrid Phone
VoIP Phone
SLNet Channel
SLNet Licenses
The SL2100 requires licenses BE116748 for SLNet channel availability.
Refer to the licensing manual for further information on licenses and the LMS (NEC's License Server).
Configuration Procedure
Before starting you will need to know the following information:
The LAN settings to configure the SL2100 to join the customers network or voice LAN. The SL2100 will require
two IP addresses in the customers network
o
IP Address & Subnet Mask
o
IP Address for VoIP media resource
o
Default Gateway IP address
The remote node addresses;
o
IP addresses of each remote SLNet node
Network Numbering Plan
o
The complete numbering plan for all SLNet nodes & will F-Route be used
o
Trunk access/routes, if using trunks at remote nodes
Centralised Voicemail
o
The voicemail Pilot number must be within the SLNet Numbering Plan
.
Quick Install Guide – SL2100 SLNet rev1.0
Quantity of DSP resources required
SIP
Digital/Analog/Hybrid
Trunk
2
1
2
2
VoIP
Phone
Phone
1
2
0
1
1
0
1
2
13
SLNet
channel
2
1
2
2