Federal Communications Commission (Fcc) - Philips PH11107-B Quick Installer's Manual

Quick Installer Guide for Philips miniPCI 802.11a/b/g card
II. Regulatory Information
To identify this product refer to the part or model number on the product
•
label
A. F C
EDERAL OMMUNICATIONS
FCC Modular Labeling Requirements:
The modular transmitter must be labeled with its own FCC ID PUBWCM1008, and, if the
FCC ID is not visible when the module is installed inside another device, then the outside of
the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following: "Contains
Transmitter Module FCC ID: PUBWCM1008" or "Contains FCC ID: PUBWCM1008."
FCC Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
C (FCC)
OMMISSION
- 31 -