Brand Codes - Silvercrest KH2150 Operating Instructions Manual

Note:
For a television, press the device button TV (4), then continue
with step 8.
7. Press the up or down arrow button (6). The next device
appears in the LCD display (2).
8. Confirm the selection with the
KEY? appears on the LCD display (2).
Note:
The remote control searches the device list in the forward direction.
To change the search direction, press "Minus" on the CH button
(17). To return to a forward search, press "Plus" on the CH
button (17).
9. Press the "Plus"
responds.
OK
10. Press the
SUCCESS appears in the LCD display (2).
11. Press various buttons on the remote control to check the
setting. If your device only partially responds, repeat the
steps with the next device code.

BRAND CODES

Select a manufacturer code from the "Manufacturer codes"
table. The table can be found at the end of the operating in-
structions.
Note:
To conclude your input, press the EXIT button (8).
1. Switch on the device for which you would like to program
the remote control.
S
2. Hold the button (5) pressed until CODE-SETUP appears
in the LCD display (2).
3. Press the right arrow button (6). LIST CODES appears in
the LCD display (2).
4. Press the down arrow button (6) repeatedly until BRAND
CODES appears in the LCD display (2).
5. Press the right arrow button (6). MODE KEY? appears in
the LCD display (2).
6. Press the desired device button (4). DEVICE? TV appears
in the LCD display (2).
Note:
For a television, press the device button TV (4), then continue
with step 8.
7. Press the up or down arrow button (6). The next device in
the list is displayed.
CH
button (17) repeatedly until your device
button (7). The device code is saved.
19
OK
button (7). SEARCH