Toro 1800 Power Curve Set-Up/Assembly page 3

7. Turn the chute crank rod lightly until the flattened
end drops into the slot in the chute crank gear (Fig.
009).
8. Firmly push the chute crank rod into the chute crank
gear until it snaps into place (Fig. 010).
Service Instruction TSN0001a
Fig. 009
PICT-1444
Fig. 010 PICT-1447a
1800 POWER CURVE
9. Ensure the mounting plate holes are aligned with the
upper and lower tubing holes (Fig. 011 - LH hole).
10. Insert the LH bolt though the holes (Fig. 012).
Note: Insert the screws from the outside of the
mounting plate. Be careful not to damage the
internal wiring when you insert the screws.
If the wiring blocks the hole, use a blunt
end punch to route the wiring away from the
aligned holes.
Fig. 011
PICT-1449
Fig. 012 PICT-1451
3