Advertisement
5
Install the batteries
Left side
. Check the LED display.
The transmitter starts when the batteries are installed. The LEDs of the transmitters light as follows depending on the actual sensor mode.
• When it is in pedaling monitor mode:
The LEDs light green for 10 seconds
• When it is in dual power meter mode:
The LEDs light orange for 10 seconds
• When it is in single power meter mode:
The LEDs blink orange for 10 seconds
• If the LEDs do not light for more than 5 seconds after installing the batteries, remove the batteries once, and after more than 1 minute, install them
again. If the LEDs still do not light, the battery may be almost empty. Replace the battery with a new one. Dispose of useless batteries as instructed by
the local government.
7
Install the right transmitter cover.
While tightening the screws, do not use excessive force or over-tighten them. The plastic cover can crack if
Use a tool that can measure the torque to tighten the screws.
13
Right side
Water-proof
packing
LED
Push switch
Advertisement
