Installing An Rru Rf Jumper - Huawei RRU3268 Installation Manual

RRU3268
Installation Guide
Figure 9-11 Correct position of an OT terminal
Step 3 Label the installed cables according to the instructions in Attaching a Cable-Tying Label.
----End

9.6 Installing an RRU RF Jumper

This section describes the procedure for installing an RRU RF jumper.
Procedure
Step 1 Connect the DIN male connector at one end of the RRU RF jumper to the ANT port on the RRU,
and use a torque wrench to tighten the connector to 25 N·m (221.27 lbf·in.), as shown in
9-12.
Figure 9-12 Installing an RRU RF jumper
Issue () Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing RRU Cables
Figure
100