To Change The Keypad; To Replace The Emc Filter - Husqvarna 536LiL Workshop Manual

5.4 To change the keypad

CAUTION: Do not bend the keypad.
CAUTION: The cable that is connected the
keypad is very easily damaged.
1. Disassemble the operating handle. See
handle on page 37 .
2. Disconnect the cable from the keypad.
3. Clean the surface where the keypad is attached.
4. Make sure that the temperature is minimum 15°C.
Make sure that the temperature of the surface where
the keypad is attached does not change more than
±3°C from the ambient temperature.
20 - Repair instructions
Operating
>15°C
5. Remove the protective tape from the new keypad
and put it on the holder. Apply pressure to the
keypad, 10 N/cm².

5.5 To replace the EMC filter

1. Disconnect the wires (A, grey), (B, black) and (C,
red) from the motor and remove them from the EMC
filter (D).
A
B
C
2. Put the wires 2 times through the EMC filter (D).
Note: Always replace a damaged EMC filter with a
new one.
3. Connect the wires to the control unit with (A, grey) at
the top, (B, black) in the middle and (C, red) at the
bottom.
Note: No EMC filter on products LiLX/iLX, LiRX/iRX
201814XXXXX
2
10 N/cm
>10 sec
D
737 - 002 - 25.10.2018