Changing Regional Settings - Siemens SIMATIC HMI Operating Instructions Manual

NOTICE
Time-dependent reactions
You have to synchronize the date and time when time-controlled responses are triggered in
the PLC by the HMI device.
See also
Restarting the HMI device (Page 156)
6.6.2

Changing regional settings

Introduction
In different countries, for example, the date, time and decimal points are displayed
differently. You can adjust the display format to meet the requirements of different regions.
The country-specific settings apply to the current project. If the project language is changed,
the country-specific settings are also changed.
Requirements
You have opened the "Regional and Language Settings" dialog with the
"Regional Settings"
①
Procedure
Proceed as follows:
1. Select the region from the selection box.
2. Change to the "Number", "Currency", "Time" and "Date" tabs and set the selection boxes
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
icon.
Region selection box
to the desired settings.
Configuring the operating system
6.6 Changing HMI device settings
149