Siemens SIMATIC HMI Operating Instructions Manual page 38

Safety instructions, standards and notes
2.2 Standards, certificates and approvals
The approval is only valid in the case of battery operation or when stationary in the charging
station.
Marking for Australia
The HMI device, charging station, power supply unit, and transponder satisfy the
requirements of Standard AS/NZS 2064 (Class A).
Wireless approval
The HMI device wireless approvals for the various countries are located as follows:
● On the rear of the HMI device
● In the product information supplied together with the HMI device
BGIA
The BGIA confirms that the HMI device satisfies the requirements of the standards below
with regard to its safety functions.
● SIL3 in accordance with IEC 61508-1 to 4
● Category 4 in accordance with EN 954-1.
● Pl e and Cat. 4 in accordance with EN ISO 13849-1
● ISO 13850
● Principle for testing and certifying "Bus systems for the transmission of safety-related
● Principles for testing and certifying electromechanical enabling switches and devices,
TÜV
The TÜV confirms that the HMI device satisfies the requirements of the standards below with
regard to its safety functions.
● SIL3 in accordance with IEC 61508-1 to 4
● Category 4 in accordance with EN 954-1.
● Pl e and Cat. 4 in accordance with EN ISO 13849-1
● EN 60204-1
38
N117
information", GS-ET-26 Electrical Engineering Technical Committee, Edition 05.2002
GS-ET-22 Electrical Engineering Technical Committee, Edition 11.2005
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01