Mitsubishi Electric CP-D70DW Operation Manual page 15

BEFORE OPERATION
Press the POWER switch on the rear panel to turn on the power.
After the mechanical initialization is completed, press the OPEN
button to pull out the printing unit.
Pull the knob to open the door.
Install the print paper into the unit.
Make sure to install the print paper firmly.
Install the print paper into the unit slowly. If it is dropped along the ditches, the unit
or accessories may be damaged.
Remove the sticker, insert the print paper between the roller and
guide as shown right, and feed the print paper until the buzzer
sounds.
• Remove the sticker before inserting the print paper between roller and guide.
Make sure to insert the paper straight.
• Keep the roller clean. Dirt on the roller may degrade the print quality.
• When taking the print paper out, pull it up toward you by holding the paper
flanges.
• Make sure to turn on the power before replacing the print paper.
• Make sure to eliminate any slack from the print paper. If you carry out the
following steps without eliminating the slack, the print paper may be damaged.
Close the door.
NOTE
NOTE
NOTE
POWER switch
Knob
Direction of paper insertion
Print paper
Roller
Guide
12