Mitsubishi Electric CP-D70DW Operation Manual page 17

BEFORE OPERATION
Push the printing unit to close.
When new print paper is mounted and the printing unit is closed with the power
turned on, the paper is automatically fed and cut.
• When closing the door, push it until a click is heard.
• If the PAPER RIBBON indicator illuminates when the printing unit is closed, the
print paper may have not been installed correctly.
In this case, open the printing unit to make sure that the print paper has been
installed correctly. Then close the printing unit again.
• When the print paper is installed more than three times, the print paper may be
used up earlier than the ink ribbon.
Installation of the print paper and the ink ribbon is completed.
• Make sure to replace the print paper and the ink ribbon simultaneously.
• When replacing them, throw away the paper chips in the paper strip bin.
• Whenever you replace the print paper and the ink ribbon, clean the thermal head
and the platen roller. For the cleaning procedures,
and 22).
NOTE
NOTE
see "CLEANING" (on pages 21
14