2. INSTALLATION PROCEDURE
Install the Remote PIM System according to the following procedure.
installation procedure for the main site and the remote site.
For the main site, this manual describes only the installation procedure exclusively required for the
Note:
Remote PIM System. Refer to the Installation Procedure Manual for regular installation.
CHAPTER 3
Page 16
Revision 2.0
START
Switch Setting of DAIA Card
Mounting of DAIA Card
Switch Setting of DAIC Card
Mounting of DAIC Card
Mounting of BS00 Card
Mounting of CP01 Card
BUS Cable Connection
Connection Between
Main Site and Remote Site
MP Reset
END
Figure 3-3
Installation Procedure for Main Site
ND-46550 (E)
Figure 3-3
and
See Section 2.1.1
See Section 2.1.2
See Section 2.1.3
See Section 2.1.4
See Installation Procedure Manual
and Circuit Card Manual .
* These procedures are required even if the main
site is 1-PIM configuration.
See Section 2.1.5
See Section 2.3
See Section 2.4
Figure 3-4
show the