Table of Contents
Advertisement
2.1.2 Mounting of DAIA Card
STEP 1: Set MB switch on the DAIA card to up position.
STEP 2: Mount DAIA card in the AP slots (AP0-AP7) on the Main Site PIM0-PIM5.
A maximum of three DAIA cards can be mounted.
the mounting location of the DAIA card.
On the multiple PIM configuration, the DAIA card(s) must be mounted on the
first/last PIM due to the number of connectors of a BUS card.
After mounting the card, set MB switch to down position.
Main Site
PIM0-PIM5
DAIA CARD
Note 1:
For mounting the DAIA card on the slot marked , the CN connector on the DAIA card should be
used.
Note 2:
When the clock signal is supplied from a master office, Mount DAIA cards (DAIA0, DAIA1) in
PIM0 in order to receive the clock signal.
Figure 3-6
Mounting Location of DAIA Card
ND-46550 (E)
Figure 3-6
shows
*
*
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
CHAPTER 3
Page 23
Revision 2.0
Advertisement
Table of Contents
