Hitachi Advanced Server DS120 Hardware Manual page 7

To reduce the weight for easier handling, remove any easily detachable compo-

nents.
Never lift or move your system soley by the handle on the component.

Power and Electrical Warnings
CAUTION!
!
M
AKE SURE THE SYSTEM IS REMOVED FROM THE RACK BEFORE SERVICING ANY NON
T
HE BUS BAR CLIPS MUST BE DISCONNECTED FROM THE POWER SYSTEM IN ORDER TO FULLY SEPARATE THE SYS
TEM FROM THE POWER SOURCE
CAUTION!
!
T
O AVOID RISK OF ELECTRIC SHOCK
FROM THE RACK
System Access Warnings
CAUTION!
!
T
O AVOID PERSONAL INJURY OR PROPERTY DAMAGE
ACCESSING THE INSIDE OF THE PRODUCT
Disconnect from the power source by removing the system from the rack.

Disconnect all cabling running into the system.

Retain all screws or other fasteners when servicing. Upon completion servicing, secure

with original screws or fasteners.
CAUTION!
!
I
F THE SERVER HAS BEEN RUNNING
CAUTION!
!
U
NLESS YOU ARE ADDING OR REMOVING A HOT
.
VICING
CAUTION!
!
T
O AVOID INJURY DO NOT CONTACT MOVING FAN BLADES
,
FAN DO NOT OPERATE THE SYSTEM WITHOUT THE FAN GUARD IN PLACE
Rack Mount Warnings
The following installation guidelines are required by UL for maintaining safety compliance
when installing your system into a rack.
The equipment rack must be anchored to an unmovable support to prevent it from tip-
ping when your system or piece of equipment is extended from it. The equipment rack
must be installed according to the rack manufacturer's instructions.
.
,
DISCONNECT ALL CABLING FROM THE SYSTEM AND REMOVE THE SYSTEM
.
:
,
ANY INSTALLED HDD MODULES MAY BE HOT
,
THE FOLLOWING SAFETY INSTRUCTIONS APPLY WHENEVER
- ,
PLUG COMPONENT ALLOW THE SYSTEM TO COOL BEFORE SER
. I
F YOUR SYSTEM IS SUPPLIED WITH A GUARD OVER THE
.
P M
RECAUTIONARY EASURES
- .
HOT PLUG COMPONENTS
-
.
-
XII