Cordless Shaving - Silvercrest SRR 3.7 B2 Operating Instructions Manual

Cordless shaving

shaving!
This shaver can be used without the power cable . In this
case, you must charge the appliance before first use
(see section "Charging the battery") .
1) Ensure the cutter block 2 is attached and locked in
place .
2) Remove the protective cap 1 .
3) Press the switch lock 7 and push the on/off switch
6 towards the cutter block 2 . The green power
light 8 lights up and the shaver starts .
Best results are achieved if used on dry skin.
It can take 2 to 3 weeks until the skin is accustomed to
the dry shaving system.
4) Move the shaving heads with straight and circular
motions over the skin .
5) After you covered all the areas you want to shave,
set the on/off switch 6 back into its initial position .
The appliance stops and the green power light 8
turns off .
SRR 3.7 B2
This appliance is not suitable for wet
│
15
US-EN
■