Changing The Cycle Time - Siemens SIMATIC S7-1500 Getting Started

3.2.4.2

Changing the cycle time

Introduction
In the following section, you will change the cycle time for the "Main" program block.
Requirement
● The program block "Main" [OB35] is contained in the library
● The FB/FC calls exist
Procedure
1. Open the properties of the "Main" program block.
2. Select the "Cyclic interrupt" option under "General".
3. Enter the new value for the "Cycle time" and click "OK".
Result
The cycle time is changed.
S7-1500
Getting Started, 05/2014, A5E03981761-AC
Software section
3.2 Creating the program
53