Reading Mode; Events Memory - Siemens CC62P User Manual

2. Press PROGRAMMING again.
3. Press FORWARD until you reach the desired number of hours:
4. Press ENTER to memorise.
5. Press FORWARD to programme the following group -if there is one and you want to
6. Press ENTER to exit.
4.3
This menu allows the programming of the cyclical ventilation time: from 5 to 30 minutes, that will be
settled for all groups in that module line. Default programming of cyclical ventilations is 5 minutes.
1. Press PROGRAMMING.
Programmed number of minutes is displayed -default "5"-.
2. Press FORWARD until you reach the desired number of minutes: from 5 to 30 min.
3. Press ENTER to memorise.
NOTE: This function remains unoperative if EXP gases have been programmed.
4.4
This menu allows to program the mode in which the Module Line will show the detectors status.
• Sequential: 1, 2, 3, etc, until displaying all detectors installed.
• Maximum Reading: The display will show first the detector with highest concentration in each group
or the one programmed with the lowest number if the concentration is the same in all detectors.
Default programmed reading mode is sequential, to change it proceed as follows:
1. Press PROGRAMMING.
2. Press FORWARD.
3. Press ENTER to memorise.
4.5
In this menu all events stored in the memory can be displayed, up to 100 events.
1.Press PROGRAMMING.
2.Press FORWARD.
3.Press PROGRAMMING.
4.Press PROGRAMMING. The event is shown on the top line of the display, while the
16
Fire & Security Products
Siemens Building Technologies - 03.2012
The current ventilation interval is shown -default "0"-.
1, 3, 6, 12 or 24 hours.
program it-.
Cyclical ventilation time

Reading mode

The default programmed mode or the last one selected is displayed.
The opposite reading mode is displayed.

Events memory

"User Program" is displayed.
"Events Memory" is displayed.
"Look Events" is displayed.
SiemensUserMan-v03