Sony XDCAM EX PMW-EX1 Operating Instructions Manual page 98

CAMERA SET
Menu items Subitems and setting values Contents
Shot
Trans Time
Transition
Setting the
Trans Speed
operating
conditions of Shot
Time / Speed
Transition
Trans Curve
Start Timer
Rec Link
MF Assist
Turning the MF
Assist Function
on/off
Color Bar Type
Selecting the types
of color bar
Flicker Reduce
Mode
Setting Flicker
Compensation
Frequency
Zoom Speed High
Setting the zoom
speed
Low
Remote
98 Setup Menu List
2 to 15 sec (4 sec)
1 to 10 (5)
Time / Speed
Linear / Soft Trans / Soft Stop
Off / 5 sec / 10 sec / 20 sec
Off / Shot-A / Shot-B
On / Off
Multi / 75% / 100%
Auto / On / Off
50 Hz / 60 Hz
0 to 99 (70)
0 to 99 (30)
0 to 99 (50)
Set the time it takes to make a shot transition.
Set the speed of the transition.
Determine whether to specify the transition by time or speed.
Select the transition pattern.
Linear: To make the transition linearly
Soft Trans: To make the transition slowly at the beginning and
end, but linearly in between
Soft Stop: To make the transition slow down near the end
Set the waiting time until the shot transition begins.
Set the function to start a shot transition linked to recording
start.
Off: To start the transition using a button without linked to
recording start
Shot-A: To start a transition to Shot-A linked to recording
start
Shot-B: To start a transition to Shot-B linked to recording
start
Set to "On" to precisely adjust the focus automatically after
you roughly adjust it manually.
Select the type of color bars displayed when you press the
BARS/CAM button.
Multi: To output multiformat color bars
75%: To output 75% color bars
100%: To output 100% color bars
Set the operation of the Flicker-Reduction function.
On: To always activate it
Auto: To automatically activate it when flicker is detected.
Off: To not activate it
Set to the power supply frequency of the light source causing
flicker.
Set the speed of zooming to be executed when you press the
on-handle ZOOM button with the zoom speed switch set to
H.
Set the speed of zooming to be executed when you press the
on-handle ZOOM button with the zoom speed switch set to L.
Set the speed of zooming to be executed when you press the
ZOOM button of the IR Remote Commander.