Cleaning - Mitsubishi Electric NJ-EX107H Instruction Manual & Recipes

Tips

Cleaning

Clean the Parts after Use Every Time
Cartridge
* Do not wash it with the nylon surface of a cleaning
sponge (doing so may cause damage).
How to remove the
cartridge
First remove the heat
sink.
1
2
(release the part).
3
4
here
How to attach the cartridge
1
Attach the cartridge
* Do not attach the packing
by twisting it (doing so
may cause steam to leak).
2
claws into the
holes and close
the cartridge.
3
4
Insert the lower part and
then push in the upper part.
If you do not attach the cartridge, the heat sink cannot be attached.
How to attach the bush
Bush
Attach the bush correctly.
Not doing so may cause
boiling over.
22
Before cleaning, pull out the power plug, remove the main unit plug, and then wait until the main unit cools.
Wash it
thoroughly
to ensure
tasty rice.
(cannot
be
released)
Insert the packing into the
groove so that the circular
surfaces of the packing are
Hole at the top and bottom.
Tank
off the water.
* Do not scratch the water level
sensor surfaces (inside and
outside)
How to remove the tank
1
2
Pipe
of the
Clean the inside
Pipe
of the pipe as well.
(Remove rice grains and
other foreign matter.)
(inside the pipe)
Do not remove this part.
* Do not pull or turn the check
valve (doing so may cause steam
to leak).
3
4
Hold the tank cover with
both hands and push it downward.
How to attach the
Align the 4
protruding parts
tank
at the tank bottom
and push into the
1
main unit.
2
3
Water level sensor
part).