Mfd; Final Check For 1Mby T E Mode - Sony MP-F17W Service Manual

3-4 FINAL CHECK
3-4-1 Final Check for 1MBJ"te Mocle
)-4-1-1 Settiq of SMC S,stCIII
a. Refering to Fig. 2-15. connect the drive to
SMC system.
b. Set the PORT SELECT .witch of SMI-7016 to
"ON". (Refer to Operating Instruction.)
c. Set the XADJ switch on the Fixture-l0 to
"OFF".
d. Place AUTO START .witch located on the
left side pand to "DISK".
)-4-1-2 Set the Test Coodiuoa
Dacripuoa Keying
To display original test condition of
ffIlIDlmffl
the drive.
1.
To change any of test condition.
[[!]
1-1. To change test mode of the drive.
[fiI
(EX)
In case it is 1.0M/300rpm.
[[!]
(This control returns to command
table.)
_.,A_
e. Set the 0 RIVE SELECT switch (SI01) of the
unit to ")" (most left side).
f. Insert the CP/M Disk into drive A.
g. Turn on the power switch of SMC system.
"A>" is displayed on screen.
h. Set the MOTOR ON switch on IF Board
52/53 to "ON" and POWER SEL switch to
"OFF".
i. Eject the
CP/M Disk and then insert the
MFD System Disk.
j. Perform keying
[!J1ID[m1Il
and IRElURNI •
DisplaY'
TEST Condition
Test Mode 1.0M/300rpm
Tes t Tr ack 0 to 79
Command Table
F 1: Chang e Tea t Condi tion
F2:
F3: Read Test
F4 : Write Test
Set-Up Command
Fl : Change Test Mode
F2: Change Test Track
F3: Change Wr i te Data
Fl F2 F3 F4 F5
300rpm 1.0M 1.6M 2.0M
-- --
600rpm
--
--
-- --
1.0M
TEST Condition
Test Mode 1.0M/300rpm
Tea t Track 0 to
79
Command Table
F 1: Change Tea
t
Cond i don
F2:
F3 : Read Tea t
F4: Wei
te
Tea t