Table of Contents
Advertisement
Desktop Terminal
5
1 PROCESSOR jack (8-pin modular)
Connect to the DESKTOP TERMINAL jack on the
Multimedia Terminal Processor using the Desktop
Terminal cable. If you use any other cable than the
supplied cable, the USB function does not work.
2 I/1 button and power/standby lamps
Press this button to turn into standby mode. The
standby lamp flashes in orange. To turn on, press this
button again. The power lamp lights up in green.
3
1 jack (minijack)
Connect the supplied microphone to this jack.
4
2/3 jacks (minijack)
Connect the PCS-A300 Microphone(s) to these jacks.
5
(USB) 1/2/3 jacks (USB 1.1 type A)
Connect to a USB compatible device.
Note
The USB compatible devices should be the following
conditions:
• Conform to Windows 2000 Professional.
1
PROCESSOR
ACCESS
6
• The total current consumption of all the connected
USB devices (except external power device)
including their rush current is 0.5 A or less .
• When using the PCS-E600 Extension Hub (not
supplied) to extend the cable, the system must
conform to the connection via the two stage USB
hub.
6 Memory Stick slot/Access lamp
Insert a "Memory Stick" into this slot.
Note
Do not remove the "Memory Stick" from the slot
while the access lamp lights up. If you do, the data in
the "Memory Stick" may be broken.
2
4
3
121
Appendix
Advertisement
Table of Contents
