Suzuki SWIFT Owner's Manual page 288

EMERGENCY SERVICE
NOTICE
Never apply a garage jack to the
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
NOTE:
For more details, contact an authorized
SUZUKI dealer.
Changing wheels
To change a wheel, use the following pro-
cedure:
1) Prepare the jack and tools.
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
WARNING
• Shift into "P" (Park) for a CVT, or into
"R" (Reverse) for a manual transaxle
vehicle when you jack up the vehicle.
• Never jack up the vehicle with the
transaxle in "N" (Neutral). Other-
wise, unstable jack may cause an
accident.
8-5
4) Remove the wheel nuts and wheel.
EXAMPLE
(1)
(2)
(3)
(4)
5) Clean any mud or dirt off from the sur-
face of the wheel (1), hub (2), thread
part (3) and surface of the wheel nuts
(4) with a clean cloth.
Clean the hub carefully; it may be hot
from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
EXAMPLE
Tightening torque for wheel nut
100 Nm (10.2 kg-m, 74.0 lb-ft)
7) Lower the jack and fully tighten the nuts
with a wheel wrench in numerical order
as shown in the illustration.
65J4033
52RM80070
57RK0-14E