Table of Contents
Advertisement
4.3.7
Small Signal Board (SSB)
1. Remove the rear cover, as described earlier.
2. Refer to figures "SSB removal" below.
3. Disconnect all cables [a] on the SSB.
4. Remove the T10 tapping screws [b] that hold the SSB. See
Figure "SSB removal".
5. Remove the screws that hold the CINCH and HDMI
connectors at the connector panel.
6. Lift the SSB from the set.
a
b (3x)
Figure 4-15 SSB removal -1-
b
Figure 4-16 SSB removal -2-
Mechanical Instructions
b (3x)
a
b (2x)
b (2x)
H_17260_036.eps
050707
b
b
b
b
H_17260_037.eps
050707
LC7.1A LA
4.3.8
Main Supply Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Main supply panel" below.
3. Unplug cables [a].
4. Remove the fixation screws [b].
5. Take the board out (it hinges at the left side).
a
Figure 4-17 Main supply panel
4.3.9
AmbiLight Interface Panel (where applicable)
1. Remove the rear cover, as described earlier.
2. Refer to fig. "AmbiLight interface panel" below.
3. Unplug the LVDS connectors [1]. Be careful as they are
very fragile.
4. Unplug the remaining connector [2].
5. Remove the fixation screws [3] and take the board out.
2
Figure 4-18 Ambilight interface panel
4.3.10 AmbiLight Unit (where applicable)
1. Remove the rear cover, as described earlier.
2. Refer to fig. "AmbiLight unit" below.
3. Unplug the connectors [1].
4. Remove the screws [2] and slide the unit sideways out of
the back cover.
4.
EN 15
b (3x)
a
a
G_16860_065.eps
010207
3
1
3
H_17270_014.eps
060707
Advertisement
Table of Contents
