Beko BCT601IG User Manual page 12

1 Hob
2 Installation clamp
3 Counter
When installing the hob onto a cabinet, a shelf
must be installed in order to separate the
cabinet from the hob as illustrated in the above
figure. This is not required when installing onto
a built-under oven.
For example, if it is possible to touch the bottom of the
product since it is installed onto a drawer, this section
must be covered with a wooden plate.
* min. 15 mm
Rear view (connection holes)
Location of the connection holes shown in the
below figure are schematic,may vary
depending on the product model. Fix them
according to connection holes on your product.
12/EN
DANGER:
Making connections to different holes is not a
good practice in terms of safety since it can
damage the gas and electrical system.
DANGER:
There are electrical components contained
within this hob, therefore when fitting the
mounting springs/clamps only attach the
supplied fixings to the connection holes shown
in this manual. Failure to observe this advise
may lead to life and property safety
The number of mounting springs on your
product varies depending on product model.
Final check
1. Operate the product.
2. Check the functions.