Parallel Connection Operation; Function; Conditions - Siemens SIMATIC S5 Equipment Manual

1.9

Parallel Connection Operation

1.9.1 Function

"operation in parallel connection"
The
(with only one encoder matching module) without additional wiring in pseudo single–channel
mode.
This means that the result from the comparison of the actual values with the setpoints can be
evaluated by reading the track identifier bits for channel 1 (tracks Oto 15) and channel 2 (tracks 16
to 31 ),
In rotary axis operating mode, this mode must be selected for
in the event of operation in parallel connection.
in the data block (IP 241) in accordance with the programming instructions (see section 9).
– In case of parameterization (without the standard function block) the following applies:
The function–associated constant F6 in the format KH (or
loaded into the start-up OBS (OB 20 to OB22), and F6 is then transferred to the set module
address +4 in accordance with section 9.5.

1.9.2 Conditions

Insert the encoder matching module of your choice for channel 1.
2. Connect the encoder to channel 1 only.
3. Required release status of the module:
4. After a power failure this function must be newly parameterized.
(There is no buffering on the IF!)
AG 1989, Order No: 6ES5 998-0KD21
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
function makes it possible to use a maximum of 32 tracks
1111
General Function Description
both
channels
0110 in the format KM) is