Trial Cutting - Brother ScanNCut DX Manual

j
After cutting off the material, confirm the instructions,
and then touch the "OK" key.
k
To feed out the cut-off material, touch the "OK" key.

The cut-off material feeds out from the back of the machine.
18

Trial Cutting

Perform trial cutting or drawing on the type of material to be
used in your project, to check that the desired result can be
achieved. This section describes the procedure for performing
trial cutting.
a
Touch the "Test" key in the cutting screen.

A test pattern is automatically arranged in the test screen.
b
Make sure that the test pattern does not overlap the
pattern for your project. To reposition the test pattern,
touch . The test pattern can also be moved by
dragging it in the screen.
a Change the pattern arrangement.
Touch to make adjustments in the editing screen when
changing the arrangement of the pattern.
If changes are applied to the pattern arrangement, the
pattern will be automatically arranged in the same location
the next time trial cutting is performed.
b Touch to adjust the pattern shape and size.
If changes are applied to the pattern shape and size, the
pattern will be automatically arranged with the same shape
and size the next time trial cutting is performed.
Memo
• As a default, the test pattern is arranged in the upper-left
corner of the cutting area.
• In order to check the result of trial cutting while leaving the
material fed in, the test pattern must be arranged lower
than the default location.
1
2
3
a Top edge of cutting area
b Line where trial cutting pattern is arranged as a default
c Test preview screen
a b