Exporting Data As Fcm File - Brother ScanNCut DX Manual

d
b c
Repeat steps and
with a weeding box.

The weeding box is created.
a Weeding box
Memo
• The data for a created weeding box is saved on a layer
separate from that for the pattern data.
for each object that will be cut

Exporting Data as FCM File

Save data as an FCM file on a computer or USB flash drive, and
then use a USB flash drive to transfer the data to the cutting
machine.

For details on transferring data directly from
CanvasWorkspace to a cutting machine, see "Sending Data
a
to the Machine" on page 8.
■ Saving to a USB Flash Drive
a
Plug the USB flash drive into a USB port on the computer.
b
In CanvasWorkspace, select [Export FCM File...] from the
[File] menu.
Note
• In order to export data for a roll feeder, [Rolled Material]
must have been selected under [Artboard Size] when the
data was edited. Before exporting the data, recheck this
setting. For details, see "Creating Data" on page 4.
c
Select [USB Drive (*)] as the destination, and then click
[Save].
* This designation differs depending on the operating system
being used.

The data is saved as an FCM file on the USB flash drive.
7