Table of Contents
Advertisement
4
Transfer the cut-out patterns to the
application sheet so that they
remain correctly arranged.
*1
The application sheet (also called a transfer paper or retack sheet) is a low-tack sheet used for attaching the adhesive craft vinyl to
the target surface. Use this sheet together with adhesive craft vinyl.
*2
Use the scraper (CASCP1) or brayer (CABRY1) for attaching the application sheet and for transferring the adhesive craft vinyl
cutouts to the target surface. To purchase a scraper (CASCP1) or brayer (CABRY1), contact the retailer where this product was
purchased.
Iron-On Transfer Material
●
Iron-on transfer material is used for heat transferring patterns onto fabric such as T-shirts and sweatshirts. The material consists of two
layers: a thermo-softening adhesive sheet and carrier sheet (paper or film). After using the cutting machine to cut out your pattern,
such as text or a logo, from only the thermo-softening adhesive sheet, attach the pattern to the target surface by pressing down on the
backing with a heat press or iron.
*
Please refer to the manufacturer's instructions included with the iron-on transfer material.
Applying the Iron-On Transfer Material to the Surface
1
Create your pattern in
CanvasWorkspace.
Make sure that the pattern is
flipped to create a mirror image. For
details, refer to the Operation
Manual for the cutting machine.
4
With the backing facing up, place
the sheet cut in step 3 onto the
*2
target surface such as fabric (
*1
When loading a roll of iron-on transfer sheet material into a cutting machine installed with the roll feeder, make sure that the
material is correctly oriented. (page 35)
*2
First check that an iron-on transfer can be applied to the target surface.
*3
The heat transfer conditions (temperature, pressing time, etc.) differ depending on the material being used. Use the material
according to the manual included with it.
34
5
After wiping the target surface
clean, attach the adhesive craft
vinyl cutouts with the application
*2
sheet. (
)
2
Half-cut the desired pattern with
*1
the cutting machine. (
)
5
Transfer the pattern with a heat
*3
press or iron. (
)
).
6
Finally, peel off only the application
sheet.
3
Peel off any excess, leaving only the pattern on the backing. (Weeding)
6
Peel off only the backing.
Hide quick links:
Advertisement
Table of Contents
