Checking Edit Points - Sony DSR-2000AP Operating Instructions Manual

Automatic Editing

Checking Edit Points

To display the time value for an edit point
74
Chapter 4 Editing
When the audio IN point is not set for insert editing of audio
only
As long as the audio OUT point is set, the VCR is ready for preview or
editing. If the audio IN point has not been set, the current tape position is
automatically used as the audio IN point.
Using a VCR without a split editing function as the player
If it is not possible to set separate audio and video edit points on the VCR
you are using as the player, by setting the audio IN and OUT points on the
recorder (this unit), then setting three video edit points, split editing is
possible.
You can check the time value for an edit point and the duration between
two edit points by displaying them in the display section.
Use the following procedure.
1
Press the RECORDER button or PLAYER button to select the VCR on
which you wish to check the edit point.
The button you have pressed lights.
2
Hold down the IN, OUT, AUDIO IN, or AUDIO OUT button
according to the edit point you wish to check.
While you hold down the button, the time value of the edit point is
shown in the display section.
Display section
2 1