14Bconfiguring Internet Explorer To Access The Sec Configuration Screens; 22Bchecking Internet Explorer; Figure 3-3 - Sec Wired To The Power Source, Microlok Ii, And Pc - Hitachi Microlok II Installation, Operation And Troubleshooting Manual

ETHERNET NETWORK

Figure 3-3 - SEC Wired to the Power Source, Microlok II, and PC

3.5 Configuring Internet Explorer to Access the SEC Configuration Screens
14B
To be able to use Internet Explorer to access the configuration functions of the SEC, you may
need to do one or both of the following:
• Specify the IP address range used by the SEC in Internet Explorer's Settings
• Delete the Temporary Internet Files saved by Internet Explorer
This section describes each of these procedures.
3.5.1 Checking Internet Explorer
22B
You may need to configure your Internet Explorer settings to allow the browser to access the
IP address range used by the SEC. The address range is specified by 169.254.*. To check
Internet Explorer and to configure it, if necessary, do the following:
1. In the Internet Explorer Tools option click on Internet Options (
Copyright 2019
+
_
POWER
SUPPLY
MICROLOK II
SERIAL CABLE
ETHERNET
PC
CROSSOVER CABLE
ETHERNET CABLE
SM6800O Rev. 1, March 2019
®
Microlok II
STANDARD
Serial-to-Ethernet Converter (SEC)
SERIAL-TO-ETHERNET
CONVERTER
Figure 3-4 ).
X X
3-4