Hitachi Microlok II Installation, Operation And Troubleshooting Manual page 42

®
Microlok II Serial-to-Ethernet Converter (SEC)
[UDP]
###################################################################
# Addresses are specified in the application as decimal.
# Addresses are specified in this niacfg.ini file as hexadecimal.
#
# Examples:
# Application / niacfg.ini
# Address 101 = 0065
# Address 202 = 00CA
#
# The format of entries in this section are as follows:
# <target ip address>:<target ip port>=<MLK PEER address list>
#
# The <MLK PEER address list> is a comma separated list of addresses
# *** NO SPACES ARE ALLOWED IN THE LIST ***
#
# A mix of MII and ATCS addressing schemes is OK
# Example:
# 192.168.1.2:60000=002B,0022,34AAAA78,43AAAA78
#
# if PAIR=1, then the pair must be present
# Example:
# 192.168.1.16:60000=00CA:0065 # PAIR=1 format
###################################################################
###################################################################
# MII_PEER1 (Port 1)
# Destination IP address 192.168.1.16, which hosts MLK Address 202
# 192.168.1.10:60000=00CA
###################################################################
[TCP]
###################################################################
# This section is similar to UDP. The difference is each
# connection has its own host port number.
#
# The format of entries in this section are as follows:
# <host ip port>:<target ip address>:<target ip port>=<MLK PEER address list>
#
# Example:
#
# 60001:192.168.1.10:60000=00CA
# 60002:192.168.1.11:60010=0002
###################################################################
[HMAC]
###################################################################
# HMAC adds a message authentication protocol on top of the PEER
# protocol. A Key Server is required for this function to work.
# When HMAC is enabled, all messages are sent encapsulated with
# the HMAC protocol.
#
Copyright 2019 SM6800O Rev. 1, March 2019 5-2