Figure 3-21 - Command Line Shell Window - Hitachi Microlok II Installation, Operation And Troubleshooting Manual

This section describes how to obtain and install a firmware upgrade from the manufacture.
To obtain and install the latest firmware image from the manufacturer, do the following:
1. Download the updated firmware from the Digi International website (www.digi.com) to a
location on your PC, such as the root directory (C:\). Remember this location to use later.
2. Open a command line shell in Windows
Programs>Accessories>Command Line Shell.
The system displays the command line shell as shown in
3. Using the cd command, change the directory to the one where you downloaded the
firmware in Step 1. If you saved your new firmware file to the root directory, type the
following on the command line and press the Enter key.
cd C:\
4. Establish an ftp connection to the Digi typing the ftp command in the command shell and
pressing the Enter key.
C:\>ftp 169.254.1.10
The system will prompt you for a username, as follows:
User name:
5. Type (none) after the prompt for your username as follows and press the Enter key:
User name: (none)
The system will prompt you for a password, as follows:
password:
Copyright 2019
There is no way to recover if the firmware is corrupted.

Figure 3-21 - Command Line Shell Window

SM6800O Rev. 1, March 2019
®
Microlok II Serial-to-Ethernet Converter (SEC)
CAUTION
®
by selecting Start>All
Figure 3-21.
X
3-18