Table of Contents
Advertisement
APPENDIX E
WARNING AND ERROR MESSAGES
The warnings and errors possible in cellular testing are outlined in the following table.
SUMMARY OF WARNING AND ERROR MESSAGES
WARNINGS
1
Power level order confirmation not accepted.
3
Handoff signaling tone out of limits.
4
Termination signaling tone out of limits.
5
Invalid DTMF keycode. (Manual Test only)
7
Incorrect SAT returned.
ERRORS
4
11
12
13
14
18
19
20
21
22
23
24
25
26
27
28
29
30
Channel out of
1-666
limit
Page response not valid
Page response not received
Alert signaling tone not accepted
Handoff signaling tone not accepted
Service request message sent by mobile in error
SAT not returned
Too many bytes in free format command
Bell command not in 1-43 range
Transceiver does not acknowledge command
Transceiver's DCL has not gone high
Transceiver has not set TCL low
Transceiver has not set TCL line high
Transceiver not powered up
Transceiver did not accept all commands words
Transceiver did not send all response words
Too many bits in response word
Too few bits· in response word
Transceiver timed out in idle state
31
32
33
34
Transceiver timed out in -data state
Opcode error
No response from transceiver
WARNING 1
Power level order confirmation not accepted. The R2008D/R2010D has sent the cellular telephone a power
level command. The telephone's confirmation has not been received or it has been detected as incorrect.
Possible causes are low cellular telephone sensitivity, excessive loss in the RF test connections or an attenua-
tion setting that is too high on the R2008D/R20IOD.
WARNING 3
Handoff signaling tone out of limits. The R2008D/R2010D has detected that a 10Khz signalling tone sent by
the cellular telephone the cellular telephone in response to a handoff message is out of limits. The typical
duration is 50 msec. This warning is displayed if the duration is outside a 40-60 msec window.
WARNING 4
Termination signaling tone out of limits. The R2008D/R2010D has detected that the duration of the termina-
tion 10 kHz signaling tone is out of limits. The typical duration is 1.8 seconds. This warning is displayed if
the duration is outside a I. 7 to 1. 9 second window.
WARNING 7
Incorrect SAT returned. The R2008D/R2010D has detected that the SAT transponded back by the cellular
telephone is out of limits. The three SAT tones are 5970, 6000 and 6030Hz. The R2008D/R20IOD allows a
window of ± 10Hz around the proper SAT. This warning can be induced if a large amount of background
noise is present while initiating a sequence test, while doing handoffs or while performing an auto test se-
quence.
30
(
Advertisement
Chapters
Table of Contents
