Kenwood NX-800 Service Manual page 15

3. Control Head Remote Kit (KRK-10: Option)
The KRK-10 remote kit is used to remotely operate the
transceiver.
3-1. Installing the KRK-10 kit to the transceiver
1. Remove the front panel from the transceiver.
2. Install the KRK-10 main panel onto the transceiver.
3. Install the KRK-10 rear panel onto the front panel.
4. Connect the KRK-10 main panel to the rear panel with
the cable.
■ Remove the front panel from the transceiver
1. Lift the two tabs of the panel on the bottom of the trans-
ceiver with a fl at-head screwdriver ( q ) and remove the
panel from the chassis ( w ).
Note: Confi rm that the tabs of the speaker hardware fi x-
ture and holder is securely fi tted in the front panel.
2. Remove the fl at cable from the connector (CN901) of the
display unit of the panel. ( e )
3. Fold the black line of the flat cable (in three parts) as
shown in Figure 3-2. ( r, t, y )
CN901
Fig. 3-1 / 图 3-1
INSTALLATION /
3. 控制头遥控套件 (KRK-10: 可选件 )
KRK-10 遥控套件用于远程操作车载对讲机。
3-1. 将 KRK-10 套件安装到车载对讲机
1. 从车载对讲机取下前面板。
2. 将 KRK-10 主控制盘安装到车载对讲机上。
3. 将 KRK-10 后面板安装到车载对讲机前面板上。
4. 用电缆将 KRK-10 主控制盘连接到后面板。
■从车载对讲机取下前面板
1. 用平头螺丝刀翘起车载对讲机底部的两个面板凸起 ( ① )，
然后从底座取下面板 ( ② )。
注意 : 请确保扬声器硬件夹具和扬声器座牢牢地固定在前面
板中。
2. 从面板显示单元的连接器 (CN901) 取下带状电缆。( ③ )
3. 如图 3-2 所示折叠带状电缆的黑线。( ④，⑤，⑥ )
安装
Chassis side
底座侧
Panel side
面板侧
Fig. 3-2 / 图 3-2
NX-800
15