Mitsubishi Electric M80 Series Maintenance Manual page 175

M800/M80/E80 Series Maintenance Manual
6 Replacing Each Unit
(5) Move the cursor to select the file. Press the [INPUT]
key.
The cursor moves as follows:
[↓] key: Auto1 -> Auto2 -> Auto3 -> Manual -> Auto1
...
[↑] key: Auto1 -> Manual -> Auto3 -> Auto2 -> Auto1
-> ...
(6) Press the [Y], [y] or [INPUT] key.
(7) The restoration is completed without error.
Note
(1) When the restoration fails, perform the restoration again otherwise it may cause an abnormal operation.
(2) Restored data writes over the previous absolute position data. Carry out the absolute position detection again after res-
toration.
(3) If you attempt to restore custom data while custom data has already been installed, the Windows-based display unit
shows the operation message "File access error", which may disable restoration. Use the integrated installer to delete
the data from the NC before restoring custom data.
IB-1501273-F
The operation message "OK? (Y/N)" appears.
<Note>
If there are no files at the position where the cursor
moved to, the operation message "Select directory to
restore" appears. Select the file again and then press
the [INPUT] key.
The restoration starts.
"Executing" and "*" are displayed for the state of file un-
der processing.
<Note>
If PLC is in operation, the message "PLC running.
Does it stop? (Y/N)" appears.
Press the [Y], [y] or [INPUT] key to continue the res-
toration.
If the tool data is being sorted, the operation message
"File access error" is displayed and the restoration
cannot be executed.
For the custom data, the restoration cannot be can-
celed during its execution.
The states of restoration-complete files turn to "Com-
plete", the operation message "Restore complete" ap-
pears.
"Unexecute" is displayed for the file which could not be
restored, for instance, due to the nonexistence of the
file.
148