Canon Booklet Finisher-D1 Service Manual page 278

5
Adjustment > Auxiliary Adjustment > Adjusting Paddle Height > Procedure
3) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the paddle position [4] is moved
down. In the same way, by pressing SW384 once, the LED [3] indicates "+1" and the
paddle position [5] is moved up.
In the case of using thin paper, perform adjustment in the direction to increase height of the
paddle position (+ direction).
• Adjustment range: +12 to -2 (0.1mm-change per unit)
NOTE:
In the case of failure as referred to above, make the adjustment in negative direction to
clear the problem.
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
5 Adjustment > Auxiliary Adjustment > Adjusting Paddle Height > Procedure
[3]
ENTER
[2]
F-5-238
[5]
[4]
F-5-239
4) Press switch SW385 [1] again to complete this adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-240
5-102
5-102