Adjustment In The Case Of Failure In Stacking Performance Of Tray (Lower Curl); Preparations; Procedure - Canon Booklet Finisher-D1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjustment in the Case of Failure in Stacking Performance of Tray (lower curl) > Procedure
Adjustment in the Case of Failure in Stacking
Performance of Tray (lower curl)
Execute this adjustment in the case of failure in tray stacking (lower curl) as shown in the
figure below or replacing the finisher controller PCB.
NOTE:
Delivery of paper with lower-curled paper stack stacked on the tray makes the delivered
paper slipped along the slope of the paper stack, and this can make the delivered paper
fall from the tray.
Executing this adjustment enables to reduce feeding speed of the finisher at the timing
that the paper's trail edge reaches the delivery roller.
This operation can prevent fall of the delivered paper from the tray because of reduced
impact from kicking of delivered paper.

■ Preparations

1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Adjustment in the Case of Failure in Stacking Performance of Tray (lower curl) > Procedure

■ Procedure

1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-246
2) Press switch SW385 [1] so that this adjustment is ready now.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-247
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-248
5-105
5-105