I Cannot Start A Hotsync; Operation When Pressing The; Hotsync Button Of The Cradle; I Cannot Stop A Hotsync ® Operation - Sony CLIE PEG-TG50 Troubleshooting Manual

Performing initial checks
B Quit applications other than the Palm™ Desktop for CLIÉ software.
If you cannot perform the HotSync
above instructions, perform a soft reset by pressing the reset button of your
CLIÉ handheld.
b
For details, refer to "Basic operations of your Sony CLIÉ™ handheld: Restarting
your Sony CLIÉ handheld" in the "Read This First (Operating Instructions)."
For particular problems about HotSync
the following.

I cannot start a HotSync

HotSync button of the cradle

B Tap HotSync and check that Local and Cradle/Cable are selected.
B Perform a soft reset on your CLIÉ handheld.
I cannot stop a HotSync
B You may not be able to stop a HotSync
a few seconds after you start a USB HotSync
while.
B If you cannot stop a HotSync
a soft reset on your CLIÉ handheld.
b
For details, refer to "Basic operations of your Sony CLIÉ™ handheld:
Restarting your Sony CLIÉ handheld" in the "Read This First (Operating
Instructions)."

It takes a long time to complete a HotSync

B Depending on the application you are using, it may take time to complete
®
a HotSync operation if the data/file is too large.
®
operation even after following the
®
®

operation when pressing the

®
operation
®
operation by tapping Cancel for
®
operation. Try again after a
®
operation even by tapping Cancel, perform
operations, refer to
®
operation

Continued on next page

• • • • • • • • • • • • • • • • • • • • • • • • •
19