Table of Contents
Advertisement
A Z 1 0 O X YG E N A N A LY Z E R | C O M B U S T I O N G A S A N A LY S I S | O I/A Z 1 0 - E N R E V. A
1
Health & Safety
Information in this manual is intended only to assist our
customers in the efficient operation of our equipment. Use of
this manual for any other purpose is specifically prohibited and
its contents are not to be reproduced in full or part without
prior approval of the Technical Publications Department.
WARNING
The installation of the equipment should be performed
exclusively by personnel specialized and authorized to work
on electrical installations, in accordance with relevant local
regulations.
To ensure that our products are safe and without risk to health,
the following points must be noted:
• The relevant sections of these instructions must be read
carefully before proceeding. Failure to do so could result in
bodily harm or damage to the equipment.
• Warning labels on containers and packages must be
observed.
• Installation, operation, maintenance and servicing must
only be carried out by suitably trained personnel and in
accordance with the information given.
• Normal safety precautions must be taken to avoid the
possibility of an accident occurring when operating in
conditions of high pressure and/or temperature.
• Chemicals must be stored away from heat, protected from
temperature extremes and powders kept dry. Normal safe
handling procedures must be used.
• When disposing of chemicals ensure that no two chemicals
are mixed.
Safety advice concerning the use of the equipment described in
this manual or any relevant Material Safety Data Sheets (where
applicable) may be obtained from the Company address on the
back cover, together with servicing and spares information.
Electrical safety – CEI/IEC 61010-1
This equipment complies with the requirements of CEI/IEC
61010-1 'Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use' and complies with
US NEC 500, NIST and OSHA.
If the equipment is used in a manner NOT specified by the
Company, the protection provided by the equipment may be
impaired.
Document symbols
Symbols that appear in this document are explained below:
DANGER
The signal word 'DANGER' indicates an imminent danger.
Failure to observe this information will result in death or
severe injury.
WARNING
The signal word 'WARNING' indicates an imminent danger.
Failure to observe this information may result in death or
severe injury.
CAUTION
The signal word 'CAUTION' indicates an imminent danger.
Failure to observe this information may result in minor or
moderate injury.
NOTICE
The signal word 'NOTICE' indicates potential material
damage.
Note
'Note' indicates useful or important information about the
product.
3
Advertisement
Table of Contents
