Safety; Health & Safety; Electrical Safety - Cei/Iec 61010-1:2001-2 - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor

1 Safety

Warning.

Installation and repair must only be carried out by the manufacturer, authorized agents or persons
conversant with the construction standards for hazardous area certified equipment.

System configuration must be carried out only by users or personnel with approved access rights
(user privileges).

Read all relevant sections of this guide before configuring the system or modifying system
parameters.

Install and use this equipment as detailed in this guide. Install and use associated equipment in
accordance with the relevant national and local standards.
Information in this manual is intended only to assist our customers in the efficient operation of our
equipment. Use of this manual for any other purpose is specifically prohibited and its contents are not to be
reproduced in full or part without prior approval of the Technical Publications Department.
1.1 Health & Safety
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:

The relevant sections of these instructions must be read carefully before proceeding.

Warning labels on containers and packages must be observed.

Installation, operation, maintenance and servicing must only be carried out by suitably trained
personnel and in accordance with the information given.

Normal safety precautions must be taken to avoid the possibility of an accident occurring when
operating in conditions of high pressure and / or temperature.
Safety advice concerning the use of the equipment described in this manual or any relevant Material
Safety Data Sheets (where applicable) may be obtained from the Company address on the back cover,
together with servicing and spares information.
1.2 Electrical Safety – CEI/IEC 61010-1:2001-2
This equipment complies with the requirements of CEI/IEC 61010-1:2001-2 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST
and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the
equipment may be impaired.
COI/AZ30E–EN Rev. D
1 Safety
3