Temperature Units - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
Parameter
...Device Setup
Oxygen Setup
%O2 Range Hi
%O2 Range Lo
Filter Time
Pressure Comp.
Temp. Setup
Thermocouple Type
K
B
N
R
S

Temperature Units

*The Endura AZ30 oxygen systems must be used only for measuring non-oxygen enriched gasses (not more than 21 %
oxygen [air]) at pressure no greater than 1.1 bar absolute (44 in. WG). Operating the system in oxygen-enriched
atmospheres will invalidate / compromise certification.
Table 6.9 Device Setup Menu (Continued)
50
Comment / [Range]
Sets the maximum oxygen concentration
[0.01 to 100 % O *]
2
Sets the minimum oxygen concentration
[0.01 to 100 % O *]
2
Sets the amount of filtering time required on the oxygen
input measurement.
Note. This is a rolling-average filter.
[1 to 60 s]
Sets the pressure compensation value.
Note. Set a value if, in normal operation, positive or
negative pressure with respect to the pressure during a
calibration is present. If calibrations are performed at the
same pressure as normal operation, set this value to
0.00 psi.
[– 5.00 to 5.00 psi]
Selects thermocouple type and temperature units.
Selects the thermocouple type used for cell temperature
measurement.
For heated probes (AZ30) this is fixed as type K. For
unheated probes (AZ35), select the thermocouple type
used in the probe.
[–100 to 1300 °C (–148 to 2372 °F)]
[–18 to 1800 °C (–0.4 to 3272 °F)]
[–200 to 1300 °C (–328 to 2372 °F)]
[–18 to 1700 °C (–0.4 to 3092 °F)]
[–18 to 1700 °C (–0.4 to 3092 °F)]
Selects the temperature units to be used in the
transmitter.
6 Programming
Default
25.00 %O
2
0.01 %O
2
1 s
0.00 psi
K
°C
COI/AZ30E–EN Rev. D