ABB Endura AZ30 series Programming Manual page 94

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
Status Diagnostic Message
Icon Displayed
––C012.023––
TEST GAS VALVES
IN TEST MODE
Valves under
manual control.
No action req'd
––C010.024––
TEST GAS 1
CALIBRATION
Cal. in progress
No action req'd
––C008.025––
TEST GAS 2
CALIBRATION
Cal. in progress
No action req'd
––C006.026––
TEST GAS 1
ACCURACY CHECK
Cal. in progress
No action req'd
––C004.027––
TEST GAS 2
ACCURACY CHECK
Cal. in progress
No action req'd
––C002.042––
CONFIGURATION
MODE
Device is being
configured.
No action req'd
Table 9.5 Diagnostics – Check Function Messages (Continued)
92
Possible Cause(s)
Calibration in progress.
Calibration in progress.
Calibration in progress.
Calibration in progress.
Calibration in progress.
Calibration in progress.
9 Troubleshooting
Corrective Measure(s)
No action required.
No action required.
No action required.
No action required.
No action required.
No action required.
COI/AZ30E–EN Rev. D