Table of Contents
Advertisement
Convert an MO Jukebox to UDO or Mixed-Media Technology
1
2
Figure 7: Secure the upper interposer LVD SCSI cable to the jukebox frame
Note:
LVD SCSI cables, and that the distance between the SCSI connector and the top of the strip is at least
7/8 inch (22 mm). This is necessary for proper fit of the middle access panel.
26
d. Locate the black self-adhesive strip that shipped with the kit and remove the backing
to expose the adhesive.
e. Position the LVD SCSI cable for the lower interposer board so that it is aligned
vertically with the LVD SCSI for the upper interposer board. Push the lower interposer
board's cable up slightly so that it forms a curve between the connector and the
jukebox frame (see
1
3
Upper interposer board
LVD SCSI cable for lower interposer board
f.
Use the black self-adhesive strip to secure the LVD SCSI cable to the jukebox frame
approximately one inch below the SCSI connector (see
Ensure that there is at least 1 inch (25 mm) of the black self-adhesive strip on either side of the
Figure
7).
Black self-adhesive strip
3
3800ux/7100ux Optical Jukebox Conversion Guide
2
Figure
7).
Advertisement
Table of Contents
