Table of Contents
Advertisement
Finishing the firmware upgrade
To finish the firmware upgrade:
1. Power on the jukebox, if necessary, and wait for the power on sequence to complete.
2. Select ADMIN* > CONF* on the control panel, then use the NEXT key until you see
3. Press ENTER to select RESTORE DEFAULTS, then wait until WAIT FOR UPDATE is no
4. Connect to a host running L&TT, if necessary.
Note:
FAILED displays instead, check to be certain that the hardware is correctly installed and repeat
these procedures until READY displays.
5. Power off and on the jukebox (you must do this a second time even if you performed the
6. When the jukebox displays READY, run L&TT to ensure that the jukebox and all drives are
Note:
repeat these procedures until all drives are found.
7. If necessary, upgrade the firmware for all of the drives using L&TT.
8. The jukebox firmware should already be up-to-date. If it is not, update it now.
Note:
drives, download jukebox firmware, connect drives, and download drive firmware again.
9. Verify proper jukebox operation:
10. Enter any customer configurations that are different from the default using the CONF*
3800ux/7100ux Optical Jukebox Conversion Guide
The front panel displays the jukebox status. It should display READY, but may still display
DEVICE FAILED.
RESTORE DEFAULTS in the display.
longer shown.
a. Power off the jukebox.
b. Connect to the jukebox the computer which hosts L&TT.
c. Power on the jukebox.
READY should display once the jukebox has completed its power on procedure. If DEVICE
previous step).
found.
If L&TT does not recognize all of the drives, check that the cabling is installed correctly and
If you did not download the UDO jukebox firmware first, you may have to disconnect all
a. Check for proper drive operation by running a "random write and verify" for
approximately 2 minutes.
b. Using a new disk or a re-writable with unneeded data, check for proper jukebox
operation by running the "wellness test."
menu.
Completing the Conversion
37
Advertisement
Table of Contents
