Sony R-DG1200 Operating Instructions Manual page 45

2
Press to select "Next".
When "Save auto calibration (auto
speaker setup) results?" appears on the
TV screen, you can select whether to
confirm the warning ("Yes") or not
("No").
Follow the instructions of the TV screen
when you select "Yes".
For details on warning and error codes,
see "Message list after Auto Calibration
measurement" (page 46).
Tip
Press on the remote when "Please Press
ENTER." appears on the TV screen.
3
Press B/b repeatedly to select
"Yes", then press
4
Press V/v repeatedly to select
the Auto Calibration type, then
press .
The measurement results are saved.
5
.
6
Note
The frequency response measurement result is not
utilized in the following cases.
– The multi channel input is selected.
– "2ch Analog Direct" is being used.
– Dolby TrueHD signals with a sampling
– PCM signals with a sampling frequency of more
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.
Parameter Explanation
Full Flat Makes the measurement of
frequency from each
speaker flat.
Engineer Sets the frequency to one
that matches that of the
Sony listening room
standard.
Front Reference Adjusts the characteristics
of all the speakers to match
the characteristics of the
front speaker.
OFF Sets the Auto Calibration
EQ to off.
Press b.
The exit screen appears.
Press to exit.
frequency of more than 96 kHz are being
received.
than 96 kHz are being received.
US
45