Canon FAX-L260i Service Manual page 107

"CHECK SUB/PWD" (#083, #102)
Cause:
Subaddress or password does not coincide.
Solution: Contact the other party and match the subaddress/password.
"DATA ERROR"
Cause: The registration data in the SRAM was destroyed and a checksum error occurred due
to a dead lithium battery or SRAM failure.
(1) Press the START/COPY button, and turn the power off and on again.
Solution:
(2) Replace the lithium battery.
(3) Replace the SCNT board.
"DOC. TOO LONG" (#003)
Cause:
The document is longer than 1 metre.
Solution:
Use a copy machine to make a reduced copy of the document, then send again.
Cause: It took more than 32 minutes to send, copy, a document or receive a document.
Solution:
Divide the document and send or copy each part separately. Contact the other party
and have them divide the document and send each part separately.
"MEMORY FULL" (#037)
Cause:
The fax's memory is full because it has received too many documents.
Solution: (1) Print out any documents which are stored in memory. Then start the operation
again.
(2) If the memory contains any facsimiles you don't need, delete them.
Cause:
The fax's memory is full because you tried to send too many pages at once.
Solution:
Divide the document and send each part separately.
"NO ANSWER" (#005)
Cause: The receiving fax machine does not answer.
Solution:
Make sure you dialed the correct number. Try again later.
"NO PWD POLLING" (#084)
Cause: When selective polling, the other party's machine does not have a password reception
function.
Solution:
Redo selective polling without designating a password.
"NO PWD TX" (#081)
Cause: The other party's machine does not have a password reception function.
Solution:
Retransmit without designating a password.
"NO RX PAPER" (#012)
Cause: The receiving fax machine declares no paper in DIS, or its memory is full.
Solution: Contact the other party, and ask them to put paper in their machine, or to clear their
fax machine's memory.
"NO SLCT POLLING" (#082)
Cause: The other party's machine does not have a select polling transmission function.
Solution:
Redo polling without designating a subaddress.
FAX-L260i Chapter 3: Maintenance & Service
3-11