Canon FAX-L260i Service Manual page 165

ISDN BASIC Bitswitch SW06
Bit Function
0 Sending Complete information
element
1 Not used
2 Not used
3 Not used
4 Not used
5 Not used
6 Low Layer Compatibility
7 High Layer Compatibility
[Bit0]
For outgoing calls, the Sending Complete information element in the SETUP message can be set to
"Add" or "Don't Add." In an outgoing call, if the Sending Complete information element in the SETUP
message is not added when an Switching equipment exists which cannot receive, please set this bit to
"1." Additionally, only in the case of "ITALY", this bit's default value is "1."
[Bit6]
For all outgoing calls, the Low Layer Compatibility information element in the SETUP message can be
set to "Add" or "Don't Add." #4B ISDN BASIC Bitswitch SW03 bit4 and bit5 settings will be valid
only when this bit is set to "0."
[Bit7]
For all outgoing calls, the High Layer Compatibility information element in the SETUP message can be
set to "Add" or "Don't Add." #4B ISDN BASIC Bitswitch SW03 bit2 and #4B ISDN BASIC
Bitswitch SW08 bit2 settings will be valid only when this bit is set to "0."
ISDN BASIC Bitswitch SW07
Bit Function
0 Not used
1 Not used
2 Not used
3 Not used
4 Keep D-channel message log
5 Not used
6 Not used
7 Not used
[Bit4]
It is possible to choose to "Save" or "Don't Save" D-channel message logs as D-channel protocol
dumps.
FAX-L260i Chapter 3: Maintenance & Service
1
Add
Don't Add
Don't Add
1
Don't Save
3-69
0
Don't Add
Add
Add
0
Save