System Information Display; Input Video Setup - Sony DFS-700 Operating Instructions Manual

Setup Menu Settings
System Information Display (page 2/8)
Button Setting
F1 INFO
F2
INFO
F3
PW ON
INSTL
F5
Input Video Setup (page 3/8)
Button Setting
F1 In No.
F2 TYPE
F3
TBC
F4 +H–pos
F5
+XPT
6-8
Chapter 6 System Connections and Settings
Meaning
Display options installed.
Display software version.
Select setup mode at power on.
Install new software.
Meaning
Select input to set.
Select input signal format.
TBC Center setting for the input
signal
The output signal is output in the
correct phase if the phase
relationship of the center value with
respect to the reference
synchronizing signal is in the range
±0.3H.
Video phase adjustment of input
signal
Cross-point button assignment to
input signals
Values
CONFIG r BKDF-701/711/712
(Appears as "***" when not installed.)
To return, press F5(EXIT r).
VER r DFS-700/700P :x.xx
BKDF-712: x.xx
DATA: x.xx
Panel: x.xx
(Appears as "----" when not installed.)
To return, press F5(EXIT r).
FACTRY (factory default)/USER (user
settings)
r Press F3(OK) to confirm install; press
F5(CANCEL) to cancel.
Values (First value is factory default.)
1/2/3/4/5/6/7/8/DSK
SDI/YUV/Cps/YC/RGB/***
(Only types which can be set appear. See the table
on the next page. When F1(In No.) is set to DSK,
appears as "***".)
0H/0.5H/1H/***
This setting is not possible when TYPE is Cps or
YC.
• When SDI, YUV, Cps, YC, or RGB is selected, this
can be adjusted from –24 to +24 in steps of 2.
• When DSK is selected, this can be adjusted from
–32 to +31 in steps of 1.
1/2/3/4/5/6/7/8/***
(When F1(In No.) is set to DSK, appears as "***".)
To assign a signal, hold down the function key, and
press a cross-point button on the background bus.