Velocities - Siemens SINUMERIK 840D sl Function Manual

W1: Tool offset
2.5 2D tool radius compensation
Program code
...
Programming feed F
This feed value is effective from point P
command is programmed in the SAR block, the speed of the preceding block is valid. The
velocity defined by FAD is not used for following blocks.
2.5.4.3

Velocities

Velocities at approach
In both approach diagrams below, it is assumed that no new velocity is programmed in the block
following the SAR block. If this is not the case, the new velocity comes into effect after point P
Figure 2-9
64
Velocities in the SAR subblocks on approach with G340
Comment
(or from point P , if FAD is not programmed). If no F
3 2
Function Manual, 06/2019, A5E47435126B AA
.
4
Tools